Burcam 300828BUP 1/3HP SUB SUMP SYSTEM 115V/12V VERT/MEC User Manual download pdf

MONTHL

Y MANDA

TORY CHECK-UP:

1. Inspect the pump and the sump for any

obvious condition that necessitates cleaning,

correction, adjustement or repair.

2. Clear the sump and the surroundings of

any paper, leaves or other debris that might

clog the input openings. Remove anything

that might float into the sump.

3. Assure that the pump is secure and

vertical for proper operation.

4. Assure that there is adequate clearance

from any combustible materials or structure.

Stored materials must be kept away from the

pump. Shelves or cabinet structures must

not be in close proximity over the pump.

5. Assure that the motor is securely plugged

into a proper GFCI electrical outlet.

6. Test the ‘GFCI’ outlet by pressing its test

switch. This should prove that the outlet is

energized and will trip off to protect against a

ground fault. Be sure to reset the ‘GFCI’ by

pressing its reset switch.

7. Lift the float to prove that the pump will

start when required. (Step 8 below will test

submersible pumps with enclosed floats).

8. Put a pail of water (8 liters) in the sump to

prove that any check valve present will

permit effluent to flow.

9. Observe that the plumbing can carry the

effluent safely out of the residence.

2190 Dagenais Blvd. West TEL: 514.337.4415

LAVAL (QUEBEC) FAX: 514.337.4029

CANADA

H7L 5X9 [email protected]

INSTALLATION

INSTRUCTIONS

Your pump has been carefully packaged at the factory to

prevent damage during shipping. However, occasional

damage may occur due to rough handling. Carefully inspect

your pump for damages that could cause failures. Report any

damage to your carrier or your point of purchase.

WWW.BURCAM.COM

MODEL

300828BUP

SUBMERSIBLE

SUMP PUMP

Please read these

instructions

carefully. Failure

to comply to

instructions and

designed

operation of

this system,

may void

the warranty.

Marine battery

not included

1 2 3 4 5 6 7 8

Summary of Contents

Page 1 - 300828BUP

MONTHLY MANDATORY CHECK-UP:1. Inspect the pump and the sump for any obvious condition that necessitates cleaning, correction, adjustement or repair.2.

Page 2

SAFETY INSTRUCTIONS:This fine pump that you have just purchased is designed from the latest in material and workmanship. Before installation and opera

Page 3 - INSTALLATION STEPS

3APPLICATIONThis submersible sump pump system is designed for a permanent sump installation.To be used in a residential cottage and farm applica

Page 4 - SUMP PUMP APPLICATION

4At this step, you have the opportunity to install a 1 1/2” or a 1 1/4” discharge. We recommenda 1 1/2” ABS/DWV discharge. Connect your pipe to the p

Page 5

INSTALLATION STEPSSTEP 1STEP 2STEP 3STEP 4STEP 5STEP 6STEP 7STEP 8STEP 9STEP 10STEP 11Installation of this unit may take several hours. Before disabli

Page 6 - REPAIR PARTS

REPAIR PARTSSTEP 2Sump pit 18” diameter X 25” depthSTEP 3Determine your choiceof discharge pipe size STEP 4Install your pump incentre of pitSTEP 5Inst

Page 7 - ELECTRIC PUMP

7TROUBLE SHOOTING GUIDE CHECKLISTELECTRIC PUMPNEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE POWERCONNECTED. DON’T JUST UNSCRE

Page 8 - BATTERY PUMP

8TROUBLE SHOOTING GUIDE CHECKLISTBATTERY PUMPNEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE POWER CONNECTED.DON’T JUST UNSCREW

Comments to this Manuals

No comments

Burcam 300828BUP 1/3HP SUB SUMP SYSTEM 115V/12V VERT/MEC User Manual

Browse online or download User Manual for Pumps Burcam 300828BUP 1/3HP SUB SUMP SYSTEM 115V/12V VERT/MEC . Burcam 300828BUP 1/3HP SUB SUMP SYSTEM 115V/12V VERT/MEC SWITCH User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Pumps Burcam 300828BUP 1/3HP SUB SUMP SYSTEM 115V/12V VERT/MEC