Burcam 400500 SEWAGE PUMP 1/2HP 115V User Manual download pdf

INSTALLATION

INSTRUCTIONS

Your pump has been carefully packaged at the

factory to prevent damage during shipping.

However, occasional damage may occur due to

rough handling. Carefully inspect your pump

for damages that could cause failures. Report

any damage to your carrier or your point

of purchase.

MODEL

400500

400510

400500E

SEWAGE

PUMPS

INITIAL START UP PROCEDURES:

Inspect the pump and the sewage tank for

any obvious condition that may

necessitates cleaning, correction,

adjustement or repair.

2. Assure that the pump is secure and

vertical for proper operation.

3. Assure that there is adequate clearance

from any combustible materials or

structure. Stored materials must be kept

away from the pump. Shelves or cabinet

structures must not be in close proximity

over the pump.

4. Assure that the motor is securely plugged

into a proper ‘GFCI’ electrical outlet.

5. Test the ‘GFCI’ outlet by pressing its test

switch. This should prove that the outlet is

energized and will trip off to protect against

a ground fault. Be sure to reset the ‘GFCI’

by pressing its reset switch.

(Repeat this step monthly)

Lift the float to assure that the pump will

start when required. (Step 7 below will

test submersible pumps with enclosed

floats).

7. Pour pails of water in the sewage tank to

turn the pump on. Assure that any check

valve present will permit the sewage to flow.

8. Observe that the plumbing can pump the

sewage safely out of the residence.

(Repeat this step monthly)

www.burcam.com

2190 Dagenais Blvd. West TEL: 514.337.4415

LAVAL (QUEBEC) FAX: 514.337.4029

CANADA

H7L 5X9 [email protected]

Please read these

instructions carefully.

Failure to comply to

instructions and

designed

operation of this

system, may

void the

warranty.

1 2 3 4 5 6

Summary of Contents

Page 1 - INSTRUCTIONS

INSTALLATIONINSTRUCTIONSYour pump has been carefully packaged at thefactory to prevent damage during shipping.However, occasional damage may occur due

Page 2 - SAFETY INSTRUCTIONS:

SAFETY INSTRUCTIONS:Before installation and operation, follow these procedures:Check with your local electrical and plumbing codes to ensure you compl

Page 3 - IMPORTANTE NOTICE

3APPLICATIONSDesigned for a permanent installation for homes and cottages application. To pumping where the total head requirements do not exceed 15

Page 4 - SEWAGE SYSTEM TYPICAL PIPING

Screw the pipe with the male adaptor into the 2” discharge opening in the pump. Lowerpump with piping attached into the sewage basin. Make sure that t

Page 5 - SEWAGE PUMP APPLICATION

REPAIR PARTSSTEP 3Cement 2” adaptor topipeSTEP 2Install sewage basinSTEP 4Drill a 1/4” holeSEWAGE PUMP APPLICATIONSTEP 5Install dischargepipe and lowe

Page 6

6TROUBLE SHOOTING GUIDE CHECKLISTNEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THEPOWER CONNECTED. DON’T JUST UNSCREW THE FUSE OR

Comments to this Manuals

No comments

Burcam 400500 SEWAGE PUMP 1/2HP 115V User Manual

Browse online or download User Manual for Pumps Burcam 400500 SEWAGE PUMP 1/2HP 115V. Burcam 400500 SEWAGE PUMP 1/2HP 115V User Manual [es]

Summary of Contents

Comments to this Manuals

Related products and manuals for Pumps Burcam 400500 SEWAGE PUMP 1/2HP 115V